2021 Valid 500-220 test answers & Cisco Exam PDF
Free Cisco 500-220 Exam Questions & Answer from Training Expert ActualCollection
NEW QUESTION 28
When wireless SSIDs are configured in Dashboard, which setting on the Access Control page affects the ability of a 2.4 GHz only client device from associating to the WLAN for the first time?
- A. Dual band operating with Band Steering
- B. Content filtering
- C. 802.11r
- D. Bridge mode
Answer: A
NEW QUESTION 29
When an SSID is configured with Sign-On Splash page enabled, which two settings must be configured for unauthenticated clients to have full network access and not be allow listed? (Choose two.)
- A. Simultaneous logins
- B. RADIUS for splash page settings
- C. Captive Portal strength
- D. Firewall & traffic shaping
- E. Controller disconnection behavior
Answer: C,E
NEW QUESTION 30
Which three verbs of request are available in the Cisco Meraki API? (Choose three.)
- A. ADD
- B. POST
- C. PUT
- D. GET
- E. SET
- F. PATCH
Answer: B,C,D
Explanation:
Reference:
Cisco_Meraki_Dashboard_API
NEW QUESTION 31
What is a feature of distributed Layer 3 roaming?
- A. An MX Security Appliance is required as a concentrator.
- B. All wireless client traffic can be split-tunneled.
- C. All wireless client traffic is tunneled.
- D. An MX Security Appliance is not required as a concentrator.
Answer: D
Explanation:
Reference:
Cisco_Meraki_Best_Practice_Design/Best_Practice_Design_-_MR_Wireless/
Wireless_Layer_3_Roaming_Best_Practices
NEW QUESTION 32
Refer to the exhibit.
What is an advantage of implementing inter-VLAN routing on an MX Security Appliance rather than performing inter-VLAN routing on an MS Series Switch?
- A. The MX appliance performs data encryption for inter-VLAN traffic.
- B. The MX appliance performs AMP for inter-VLAN traffic.
- C. The MX appliance performs content filtering for inter-VLAN traffic.
- D. The MX appliance performs IDS/IPS for inter-VLAN traffic.
Answer: A
NEW QUESTION 33
How is high-availability supported for Cisco Meraki devices?
- A. The MX Security Appliances and MS Series Switches that use HSRP support an active/passive high- availability pair.
- B. Only the MX Security Appliances that use VRRP support high availability.
- C. An active/active high-availability pair is recommended for MX Security Appliances.
- D. The MX Security Appliances and MS Series Switches that use VRRP support an active/passive high- availability pair.
Answer: B
Explanation:
Reference:
_High_Availability_Pair
NEW QUESTION 34
Refer to the exhibit.
What is the minimal Cisco Meraki Insight licensing requirement?
- A. Two Meraki Insight licenses must be configured on network A and a single license must be configured on network B, to gain Web App Health visibility on network B.
- B. A single Meraki Insight license must be configured on network A to gain Web App Health visibility on network B.
- C. Two Meraki Insight licenses must be configured on network A to gain Web App Health visibility on network B.
- D. A single Meraki Insight license must be configured on network A, and a single license must be configured on network B, to gain Web App Health visibility on network B.
- E. A single Meraki Insight license must be configured on network B to gain Web App Health visibility on network B.
Answer: A
NEW QUESTION 35
Which two primary metrics does Meraki Insight use to calculate the Application Performance Score? (Choose two.)
- A. Maximum Latency
- B. Application Response Time
- C. Per-flow Goodput
- D. Total Bandwidth Usage
- E. Maximum Jitter
Answer: B,C
NEW QUESTION 36
Which Cisco Meraki product must be deployed in addition to Systems Manager so that Systems Manager Sentry enrollment can be used?
- A. MS Switch
- B. MV Smart Camera
- C. Meraki Insight
- D. MR Access Point
Answer: D
NEW QUESTION 37
What are two ways peers interact with ports that Auto VPN uses? (Choose two.)
- A. For IPsec tunneling, peers use high TCP ports within the 32768 to 61000 range.
- B. Peers contact the VPN registry at TCP port 9350.
- C. For IPsec tunneling, peers use UDP ports 500 and 4500.
- D. For IPsec tunneling, peers use high UDP ports within the 32768 to 61000 range.
- E. Peers contact the VPN registry at UDP port 9350.
Answer: A,E
Explanation:
Reference:
_Configuration_and_Troubleshooting
NEW QUESTION 38
For which two reasons can an organization become "Out of License"? (Choose two.)
- A. MR licenses that do not match the MR models in the organization
- B. licenses that are in the wrong network
- C. expired device license
- D. licenses that do not match the serial numbers in the organization
- E. more hardware devices than device licenses
Answer: C,E
NEW QUESTION 39
Which two actions can extend the video retention of a Cisco Meraki MV Smart Camera? (Choose two.)
- A. enabling motion-based retention
- B. enabling audio compression
- C. installing an SSD memory extension
- D. configuring a recording schedule
- E. enabling maximum retention limit
Answer: A,D
NEW QUESTION 40
What is the role of the Meraki Dashboard as the service provider when using SAML for single sign-on to the Dashboard?
- A. The Dashboard parses the SAML request and authenticates users.
- B. The Dashboard generates the SAML request.
- C. The Dashboard provides user access credentials.
- D. The Dashboard generates the SAML response.
Answer: B
NEW QUESTION 41
Refer to the exhibit.
A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?
- A. The packet is stopped.
- B. Not enough detail is available to determine the next hop.
- C. The Auto VPN peer "Store 1532 - appliance" is the next hop.
- D. The concentrator gateway (10.128.124.62) is the next hop.
Answer: B
NEW QUESTION 42
Refer to the exhibit.
Which IDS/IPS mode is the MX Security Appliance configured for?
- A. quarantine
- B. prevention
- C. detection
- D. blocking
Answer: B
NEW QUESTION 43
Refer to the exhibit.
This Dashboard organization uses Co-Termination licensing model.
What happens when an additional seven APs are claimed on this network without adding licenses?
- A. All APs stop functioning in 30 days.
- B. One AP Immediately stops functioning.
- C. All APs immediately stop functioning.
- D. All network devices stop functioning in 30 days.
Answer: D
NEW QUESTION 44
Which order is accurate for a firmware upgrade on MX appliances in a high-availability configuration?
- A. starts on the primary MX appliance and then occurs on the secondary MX appliance
- B. starts on both MX appliances at the same time and then immediately reboots both appliances
- C. starts on both MX appliances at the same time and then reboots both appliances after traffic on the primary MX appliance ceases
- D. starts on the secondary MX appliance and then occurs on the primary MX appliance
Answer: A
NEW QUESTION 45
Which two Systems Manager Live tools are available only for Apple Macs and Windows PCs and cannot be used on iOS or Android mobile devices? (Choose two.)
- A. Remote Desktop
- B. OS updates
- C. Send notification
- D. Selective wipe
- E. Screenshot
Answer: A,D
NEW QUESTION 46
Company iPads are enrolled in Systems Manager without supervision, and profiles are pushed through Systems Manager.
Which outcome occurs when a user attempts to remove the "Meraki Management" profile on an iPad?
- A. The "Meraki Management" profile cannot be removed.
- B. The "Meraki Management" profile is removed and then pushed automatically by Systems Manager.
- C. The "Meraki Management" profile is removed. All the profiles that Systems Manager pushed are also removed.
- D. The "Meraki Management" profile is removed. All the profiles Systems Manager pushed remain.
Answer: C
NEW QUESTION 47
What are two roles of the network and device tags in a Dashboard? (Choose two.)
- A. Network tags can be used to simplify the assignment of network-level permissions in an Organization with many networks.
- B. Device tags can be assigned to MR APs to influence the gateway selection for repeaters in a mesh wireless network.
- C. Device tags can be used to simplify the assignment of device-level permissions in an Organization with many administrators.
- D. Tags enable administrators to configure a combination of network and device specific tags to create summary reports filtered for specific devices across multiple networks.
- E. Network tags can be used to assign networks to separate Auto VPN domains in an Organization with many networks.
Answer: B,D
Explanation:
Reference:
Organization_Menu/Manage_Tags
NEW QUESTION 48
......
Cisco 500-220 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
| Topic 7 |
|
| Topic 8 |
|
| Topic 9 |
|
| Topic 10 |
|
| Topic 11 |
|
| Topic 12 |
|
| Topic 13 |
|
Top Cisco 500-220 Courses Online: https://www.actualcollection.com/500-220-exam-questions.html