Guide (New 2021) Actual Cisco 300-410 Exam Questions [Q84-Q104]

Share

Guide (New 2021) Actual Cisco 300-410 Exam Questions

300-410 Exam Dumps Pass with Updated 2021 Certified Exam Questions


What Is the Cisco ENARSI 300-410 Exam?

As was said above, Cisco ENARSI 300-410 is one of the six concentration exams associated with CCNP Enterprise. This test assesses the applicant's knowledge of handling VPN services, Layer 3 technologies, security in infrastructure, and troubleshooting skills.

The duration one gets to complete the exam is currently set at 90 minutes. The test is offered in English as well as Japanese languages. Candidates can expect a mix of multiple-choice, multiple answers, and drag and drop questions. A fee of $300 is charged from each exam-taker for every attempt, and the registration is held through Pearson VUE.


Cisco 300-410 is a concentration exam that the applicants have to pass in order to obtain two certifications: Cisco Certified Specialist – Enterprise Advanced Infrastructure Implementation and CCNP Enterprise. This test measures their knowledge and skills in implementing and troubleshooting advanced routing services & technologies. These include Layer 3, VPN services, infrastructure security, infrastructure automation, and infrastructure services. Moreover, the potential candidates for the CCNP Enterprise certificate must take the core exam, which is Cisco 350-401, to fulfill the requirements for getting this sought-after certification.

 

NEW QUESTION 84
Refer to the exhibit.

An IP SLA is configured to use the backup default route when the primary is down, but it is not working as desired. Which command fixes the issue?

  • A. R1(config)# ip route 0.0.0.0.0.0.0.0.1.1.1.1 track 1
  • B. R1(config)#ip sla track 1
  • C. R1(config)# ip route 0.0.0.0.0.0.0.0.2.2.2.2
  • D. R1(config)# ip route 0.0.0.0.0.0.0.0.2.2.2.2 10 track 1

Answer: A

 

NEW QUESTION 85
Which protocol does MPLS use to support traffic engineering?

  • A. Resource Reservation Protocol (RSVP)
  • B. Tag Distribution Protocol (TDP)
  • C. Label Distribution Protocol (LDP)
  • D. Border Gateway Protocol (BGP)

Answer: A

Explanation:

 

NEW QUESTION 86
Which label operations are performed by a label edge router?

  • A. SWAP and PUSH
  • B. PUSH and PHP
  • C. PUSH and POP
  • D. SWAP and POP

Answer: C

Explanation:
A label edge router (LER, also known as edge LSR) is a router that operates at the edge of an MPLS network and acts as the entry and exit points for the network. LERs push an MPLS label onto an incoming packet and pop it off an outgoing packet.
Reference:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/mpls/configuration/guide/mpls_cg/mp_mpls_overview.pdf

 

NEW QUESTION 87
Drag and drop the DHCP messages from the left onto the correct uses on the right.

Answer:

Explanation:

 

NEW QUESTION 88
Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

  • A. Option B
  • B. Option A
  • C. Option C
  • D. Option D

Answer: A

Explanation:
Explanation
The command ip nhrp map multicast dynamic should be only used on Hub router, not spoke. If we are running dynamic routing protocols based on multicast (like RIP, OSPF, EIGRP ...) we have to add the command ip nhrp map multicast dynamic in Hub to replicate all multicast traffic to all dynamic entries in the NHRP table (multicast will be proceeded as unicast traffic) - The tunnel source FastEthernet0/0 is equivalent to tunnel source 172.17.0.2, which is the NBMA address of Spoke A.

 

NEW QUESTION 89
When provisioning a device in Cisco DNA Center, the engineer sees the error message "Cannot select the device. Not compatible with template.".
What is the reason for the error?

  • A. The software version of the template is different from the software version of the device
  • B. The tag that was used to filter the templates does not match the device tag.
  • C. The changes to the template were not committed
  • D. The template has an incorrect configuration.

Answer: B

 

NEW QUESTION 90
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.

Answer:

Explanation:

Explanation
Same Answer is already updated below:

HTTP and HTTPs run on TCP port 80 and 443, respectively and we have to remember them.
Syslog runs on UDP port 514 while NTP runs on UDP port 123 so if we remember them we can find out the matching answers easily. But maybe there is some typos in this question as 2001:d88:800:200c::c/126 only ranges from 2001:d88:800:200c:0:0:0:c to 2001:d88:800:200c:0:0:0:f (4 hosts in total). It does not cover host 2001:0D88:0800:200c::1f. Same for 2001:D88:800:200c::e/126, which also ranges from
2001:d88:800:200c:0:0:0:c to 2001:d88:800:200c:0:0:0:f and does not cover host 2001:0D88:0800:200c::1c
.

 

NEW QUESTION 91
Drag and drop the packet types from the left onto the correct descriptions on the right.

Answer:

Explanation:

 

NEW QUESTION 92
Drag and drop the DHCP messages from the left onto the correct uses on the right.

Answer:

Explanation:

Reference:
DHCPINFORM: If a client has obtained a network address through some other means or has a manually configured IP address, a client workstation may use a DHCPINFORM request message to obtain other local configuration parameters, such as the domain name and Domain Name Servers (DNSs). DHCP servers receiving a DHCPINFORM message construct a DHCPACK message with any local configuration parameters appropriate for the client without allocating a new IP address. This DHCPACK will be sent unicast to the client.
DHCPNAK: If the selected server is unable to satisfy the DHCPREQUEST message, the DHCP server will respond with a DHCPNAK message. When the client receives a DHCPNAK message, or does not receive a response to a DHCPREQUEST message, the client restarts the configuration process by going into the Requesting state. The client will retransmit the DHCPREQUEST at least four times within 60 seconds before restarting the Initializing state.
DHCPACK: After the DHCP server receives the DHCPREQUEST, it acknowledges the request with a DHCPACK message, thus completing the initialization process.
DHCPDECLINE: The client receives the DHCPACK and will optionally perform a final check on the parameters. The client performs this procedure by sending Address Resolution Protocol (ARP) requests for the IP address provided in the DHCPACK. If the client detects that the address is already in use by receiving a reply to the ARP request, the client will send a DHCPDECLINE message to the server and restart the configuration process by going into the Requesting state.
https://www.cisco.com/c/en/us/support/docs/ip/dynamic-address-allocation-resolution/27470-100.html

 

NEW QUESTION 93
What are two characteristics of VRF instance? (Choose two.)

  • A. A customer site can be associated to different VRFs
  • B. All VRFs share customers routing and CEF tables .
  • C. An interface must be associated to one VRF.
  • D. It is defined by the VPN membership of a customer site attached to a P device.
  • E. Each VRF has a different set of routing and CEF tables

Answer: A,C

Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l3_vpns/configuration/15-s/mp-l3-vpns-15-s-book/mp-bgp-mpls-vpn.pdf

 

NEW QUESTION 94
Which statement about IPv6 RA Guard is true?

  • A. It is not supported in hardware when TCAM is programmed.
  • B. Packets that are dropped by IPv6 RA Guard cannot be spanned.
  • C. It cannot be configured on a switch port interface in the ingress direction.
  • D. It does not offer protection in environments where IPv6 traffic is tunneled.

Answer: D

Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6_fhsec/configuration/xe-3s/ip6f-xe-3s-book/ip6-ra-guard.html#GUID-589AF00C-7499-439F-AD23-51005D61CAB7 The IPv6 RA Guard feature does not offer protection in environments where IPv6 traffic is tunneled.

 

NEW QUESTION 95
Drag and drop the MPLS terms from the left onto the correct definitions on the right.

Answer:

Explanation:

 

NEW QUESTION 96
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table.
What should be configured to accomplish this task?

  • A. set ip next-hop recursive
  • B. set ip default next-hop
  • C. set ip next-hop
  • D. set ip next-hop verify-availability

Answer: B

Explanation:
Section: Mixed Questions

 

NEW QUESTION 97
An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency. The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE.
Which action should be taken to resolve this issue?

  • A. match the passwords
  • B. match the hello timers
  • C. match the MTUs
  • D. match the network types

Answer: C

Explanation:

 

NEW QUESTION 98
An engineer configured access list NON-CISCO in a policy to influence routes

What are the two effects of this route map configuration? (Choose two.)

  • A. Packets are dropped by the access list.
  • B. Packets are forwarded to the default gateway.
  • C. Packets are forwarded using normal route lookup.
  • D. Packets are not evaluated by sequence 10.
  • E. Packets are evaluated by sequence 10.

Answer: B,E

Explanation:
https://www.cisco.com/c/en/us/support/docs/ip/ip-routed-protocols/47121-pbr-cmds-ce.html

 

NEW QUESTION 99
An engineer configured two routers connected to two different service providers using BGP with default attributes. One of the links is presenting high delay, which causes slowness in the network. Which BGP attribute must the engineer configure to avoid using the high-delay ISP link if the second ISP link is up?

  • A. AS-PATH
  • B. LOCAL_PREF
  • C. WEIGHT
  • D. MED

Answer: C

 

NEW QUESTION 100
Refer to the exhibit.

The neighbor relationship is not coming up Which two configurations bring the adjacency up? (Choose two)

  • A. NY
    interface E 0/0
    no ip ospf message-digest-key 1 md5 Cisco123
    ip ospf authentication-key Cisco123
  • B. LA
    interface E 0/0
    ip ospf message-digest-key 1 md5 Cisco123
  • C. LA
    router ospf 1
    area 0 authentication message-digest
  • D. NY
    router ospf 1
    area 0 authentication message-digest
  • E. LA
    interface E 0/0
    ip ospf authentication-key Cisco123

Answer: B,C

 

NEW QUESTION 101
Refer to the exhibit.

SanFrancisco and Boston routers are choosing slower links to reach each other despite the direct links being up Which configuration fixes the issue?

  • A. Option A
  • B. Option C
  • C. Option B
  • D. Option D

Answer: D

 

NEW QUESTION 102
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)

  • A. Configure a user on the source router with the username tftp password tftp command
  • B. TFTP is not supported in recent IOS versions, so an alternative method must be used
  • C. Configure the TFTP authentication on the source router with the tftp-server authentication local command
  • D. Enable the TFTP server on the source router with the tftp-server flash: <filename> command
  • E. Copy the file to the destination router with the copy tftp: flash: command

Answer: D,E

 

NEW QUESTION 103
Refer to the exhibit.

An IP SLA is configured to use the backup default route when the primary is down, but it is not working as desired. Which command fixes the issue?

  • A. R1(config)# ip route 0.0.0.0.0.0.0.0.1.1.1.1 track 1
  • B. R1(config)#ip sla track 1
  • C. R1(config)# ip route 0.0.0.0.0.0.0.0.2.2.2.2
  • D. R1(config)# ip route 0.0.0.0.0.0.0.0.2.2.2.2 10 track 1

Answer: A

 

NEW QUESTION 104
......


Having this certification opens new job opportunities as well as senior promotions in current positions you're working at. The following are only a few of the options that will be available for you as a Cisco CCNP Enterprise holder:

  • Information technology (IT) manager
  • Network architect
  • Information technology (IT) director
  • Network administrator
  • Senior network engineer
  • Network security engineer

Passing 300-410 exam also contributes to thickening your wallet! Mote, that according to PayScale, the approximate average annual salary for a CCNP Enterprise certified professional in the industry is a whopping $96k. Getting into details, senior network engineers earn an average of $101k per annum, while the average annual pay of network architects is even higher and reaches the mark of $122k as stated on the same source. If these figures cannot convince you of just how worth being CCNP Enterprise certified is, nothing else could.

 

Pass Guaranteed Quiz 2021 Realistic Verified Free Cisco: https://www.actualcollection.com/300-410-exam-questions.html

300-410 Exam Questions - Real & Updated Questions PDF: https://drive.google.com/open?id=1r1slb0tc2dwciNusPahAz-UGdq23g68F